This is a larger version of our Model “D” Machine. It was designed to accept paper 24″ wide. By doing this we are able to install three, 3-1/2″x 8″, filter dies on it. This machine will also produce a complete line of Urn Filter Dies, up to 23″ in diameter. This results in an 18% paper savings for the user. We will design this machine to the customer’s specifications. The machine requires a floor space of about 12′ wide x 80′ long and 10′ high. The total weight is approximately 18,000#, depending on how it is equipped. The electrical motor to drive this machine is a 15 Horse Power. The machine will run at 60 strokes per minute. The Cycle per minute is based on a number of variables – i.e. (Heat, Dwell Time, Open & Closed Flare of Cup, Type of Paper, Moisture Contents of Paper, Number of Sheets Per Nest and Weather Conditions.) There are no other electrics required. The purchaser will be required to supply steam up to 6 P.S.I.

The estimated time to produce a Model “E” Machine from receipt of the Purchase Order and deposit will be approximately six months.

Machine

• Paper Width Maxim (24″)
• Paper Width Minimum (16″)
• Paper Feed Rolls
• Automatic A/C speed controls 0-60 cycles per minute, –AC Tech
• Motor 10 H.P.
• Braking System Warner 12″ Brake & 15″ Clutch
• Voltage Motor – Choice
• Air Operated Paper Pusher (Waste Paper)
• Machine Width (4 1/2′)
• Machine Length (12′)
• Machine Height (8 1/2′)
• Machine Weight (18,000 #)
• Bull Gear System (24″)
• Ram Inside Diameter (10 1/8″)
• Ram Outside Diameter (11 7/8″)
• Ram Bored For Triple Header (Yes)
• Ram Bored For Double Header (Yes)
• Guards (Standard)
• Optional Standards, Domestic or International.
• Painted (Choice)

Rack

• Paper Width Minimum (24″)
• Paper Maxim Diameter (30′)
• Total Number Roll Stands (18)
• Total Number Rolls Of Paper (54) (Optional Roll Stands Upon Request)
• Brake Tension Control Manual Adjustment – Nylon
• Rack Length (45 1/2′)
• Rack Width (4′)
• Rack Height (10′)
• Nylon Bearing Idler roll